焊接头问题处理：电机不摆动（中英）

正常光斑通过摆动电机变成一条光斑线（左），如果当电机不摆动了，那么就会显示一个点出来（右）

The normal spot becomes a spot line (left) by swinging the motor, and if the motor does not swing, then a dot will be displayed (right)

原因分析：

一.软件部分是否设置正确

设置-扫描矫正：1.25

工艺-扫描宽度：焊接系统3-5，清洗系统20-150

首页-指示红光：开启

Cause analysis:

One. Whether the software section is set up correctly

Setup - Scan Correction: 1.25

Process-scanning width: welding system 3-5, cleaning system 20-150

Home - Indicator Red Light: On

二.硬件部分检查

1.摆动电机的供电为15V电源供电，我们应首先测量15V开关电源的供电是否正常。

Two. Hardware section check

1. The power supply of the swing motor is powered by 15V power supply, we should first measure whether the power supply of 15V switching power supply is normal.

2.另外，15V开关电源分正负，错误的接线也会致使电机不工作，V1接15V+，V2接15V-，15V开关电源上的任意COM接2号脚GND！

2. In addition, the 15V switching power supply is divided into positive and negative, the wrong wiring will also cause the motor to not work, V1 is connected to 15V+, V2 is connected to 15V-, and any COM on the 15V switching power supply is connected to GND on pin 2!

3.（型号SUP20S/T/C）检查一下两头的接口是否插到位和驱动板上有没有插错

3. (Model SUP20S/T/C) Check whether the interfaces at both ends are plugged into place and whether there is any misinsertion on the driver board

4.（型号SUP15S）如果电源正常，那一般都是断路导致，控制盒和电机通过一根2芯线供电，重点检查2芯线的航插，拆开看是否断路

4. (Model SUP15S) If the power supply is normal, it is generally caused by an open circuit, the control box and the motor are powered by a 2-core wire, focus on checking the 2-core wire's air plug, disassemble to see if the circuit is open

5.（型号SUP15S）当2芯线没有问题的时候，检查5芯线的信号航插，也是拆开看是否有断路

5. (Model SUP15S) When there is no problem with the 2-core wire, check the signal of the 5-core wire, and also disassemble it to see if there is an open circuit

6.检查主板与驱动的彩虹链接线是否松动

6. Check whether the rainbow link between the motherboard and the driver is loose

7.当以上都无法处理是，更换一根电机线，技术群内沟通即可

7. When the above can not be handled, replace a motor line, technical group communication can be