锐科C系X/H与控制盒的控制接线（中英）

注意：

1.请确保文中的激光器图示与您使用的激光器为同一型号

2.如激光器厂家信号更改，则下列接线失效，请按照厂家提供的定义接线

Attention:

1. Please ensure that the laser icon in the article is the same model as the laser you are using

2. If the laser manufacturer's signal changes, the following wiring fails. Please connect the wiring according to the manufacturer's definition

锐科小体积RFL-C-X/H图示

Illustration of RFL-C-X/H small volume of Rayco

激光器信号接口CTRL-INTERFACE定义(DB24)

Laser Signal Interface CTRL-INTERFACE Definition (DB24)

根据以上定义，接线方式：

1.首先短接激光器信号接口CTRL-INTERFACE(DB24)的2和3

2.DB24的12脚（模拟量+）接控制盒的信号接口三的5号脚

3.DB24的14脚（12.13的参考地）接控制盒的信号接口三的4号脚

4.DB24的15脚（调制信号MOD+）接控制盒的信号接口三的7号脚

5.DB24的16脚（调制信号MOD-的返回端）接控制盒的信号接口三的6号脚

6.DB24的18脚（使能）接控制盒的信号接口三的2号脚

7.DB24的17脚（外部供电）接控制盒的信号接口三的3号脚

8.DB24的21脚（高电平AD模式）接控制盒的信号接口三的3号脚

9.DB24的20脚（返回端）接控制盒的信号接口三的4号脚

According to the above definition, the wiring mode:

1. First, short-circuit 2 and 3 of the laser signal interface CTRL-INTERFACE(DB24)

2. Connect pin 12 (analog +) of the DB24 to pin 5 of signal interface 3 of the control box

3. Connect pin 14 of the DB24 (reference ground in 12.13) to pin 4 of signal port 3 of the control box

4. Connect pin 15 (modulated signal MOD+) of DB24 to pin 7 of signal interface 3 of the control box

5. Pin 16 of DB24 (return end of MODulated signal MOD-) is connected to pin 6 of signal interface 3 of the control box

6. Connect pin 18 (enabled) of the DB24 to pin 2 of signal port 3 on the control box

7. Connect pin 17 (external power supply) of the DB24 to pin 3 of signal port 3 of the control box

8.Connect pin 21 of the DB24 (high level AD mode) to pin 3 of signal interface 3 of the control box

9. Connect pin 20 (return end) of DB24 to pin 4 of signal interface 3 of the control box