一.参数的设置

首页的焊接模式选择：连续，并设置工艺，调整好需要的焦点

I. Parameter setting

Home welding mode selection: continuous, and set the process, adjust the required focus

二.信号的检测

只有【激光器扳机信号】和【安全地锁信号】有效时，才会出光（激光器状态正常），同时首页未出现任何报警

关于首页的报警，多数是（设置）里面的报警电平设置错误，请更改对应的报警电平

Ii. Signal detection

Only when [laser trigger signal] and [safety lock signal] are effective, light will come out (laser state is normal), and there is no alarm on the home page

About the alarm on the home page, most of the alarm levels in the (setting) are wrong, please change the corresponding alarm level

三.红光的调整

请务必红光在中心，如有偏移，请参照：红光的调整

四.铜嘴的选择

请使用对应的铜嘴焊接，请参照：铜嘴分类

Three. Red light adjustment

Make sure the red light is in the center, if there is deviation, please refer to: Red light adjustment

Four. Choice of copper nozzle

Please use the corresponding copper nozzle welding, please refer to: Copper nozzle classification