Process: parameter setting of welding head cutting超强伟业焊接头的切割设置 Cutting Settings of Super Weiye Welding Joint 一.铜嘴 Copper nozzle 使用切割铜嘴（建议铜嘴1.5以上） Use cutting copper nozzle (copper nozzle 1.5 or more is recommended).
二.工艺 Technology
与焊接不同的是，切割光斑是没有宽度的 因此扫描宽度务必设置为0，即红光为一个点 Unlike welding, the cutting spot has no width. Therefore, the scanning width must be set to 0, that is, the red light is a point. 扫描速度：无视此参数，可随意 扫描宽度：0 峰值功率：参考值建议满功率切割，以实际为准 占空比：参考值100 脉冲频率：参考1000 Scanning speed: Ignore this parameter, and you can do it at will. Scan width: 0 Peak power: the reference value suggests full power cutting, which is subject to the actual situation. Duty cycle: reference value 100 Pulse frequency: reference 1000 设置参数后，导入并返回，即可在首页的左侧看到此工艺 焦点建议使用负焦（直接影响切割效果） After setting the parameters, import and return, and you can see this process on the left side of the home page. It is recommended to use negative focus (which directly affects the cutting effect). 三.红光中心点 Red light center point 务必保证红光完全从铜嘴中心出来，否则可能烧毁铜嘴 一般使用硬件调整，即调整尾部电机 调整方法参考：红光的调整 Make sure that the red light completely comes out from the center of the copper nozzle, otherwise it may burn the copper nozzle. Generally, hardware adjustment is used, that is, adjusting the tail motor. Adjustment method reference: adjustment of red light 四.切割工件 Cutting the workpiece 焦点的要求：负焦相对效果挂渣少 气体的要求：如果对切割面有要求，建议使用氮气气体（大于6公斤），相对切割面发白 如果要求切割厚度，使用氧气或空气切割，相对切割面发黑 不建议使用氩气切割，可能造成切割效果不良 Focus requirements: the relative effect of negative coke is less slag hanging. Gas requirements: If there are requirements for the cutting surface, it is recommended to use nitrogen gas (more than 6 kg), which is whiter than the cutting surface. If cutting thickness is required, use oxygen or air to cut, and the cutting surface will be black. Argon cutting is not recommended, which may cause poor cutting effect. 切割厚度：3毫米以下最好 Cutting thickness: 3 mm or less is best. 切割时手速保持均匀 Keep the hand speed even when cutting. |
