How to adjust the red light deflection: welding head

红光偏配图.jpg

请注意：

1.只有在红光为一条线的时候可通过下列方法调试，如果红光为点，请参照线变点处理方案‍，因为不摆动的时候也有可能会偏

2.如果从保护镜那边看到是一团光而非一条线，则考虑是否为反射镜断裂

3.请务必确认15V电源状态是正常

Please note:

1. Only when the red light is a line, it can be debugged by the following methods. If the red light is a point, please refer to the line change point treatment scheme, because it may be biased when it does not swing.

2. If you see a mass of light from the protective mirror instead of a line, consider whether the mirror is broken.

3. Please make sure that the state of 15V power supply is normal.

调整方案

1.软件设置（左右调整）

通过设置界面的激光中心偏移来微调，依次是{1.设置}-{2.更改激光中心偏移数值，负值往右，正值往左，最新版本最大可调整数值+3/-3}。这种方案可以进行左右的微调，如果使用这种方法依然无法调整，则使用机械调整

2.机械调整（上下左右调整）

在进行机械调整前，请务必把设置的中心偏移设置为0

3.先看一下结构(SUP20S/T)

Adjustment scheme

1. Software Settings (Left and Right Adjustment)

Fine-tune the interface by setting the laser center offset, which is {1. Set }-{2. Change the laser center offset value, with negative value to the right and positive value to the left, and the maximum adjustable value in the latest version is +3/-3}. This scheme can be fine-tuned from left to right. If it still cannot be adjusted by this method, mechanical adjustment is used.

2. Mechanical adjustment (up, down, left and right adjustment)

Before mechanical adjustment, be sure to set the set center offset to 0.

3. Look at the structure first (SUP20S/T).

左右偏很大：松开C，转动锁紧环，转动时注意幅度，稍微用力即可（请勿转动电机部分，即带有SN码标签位置）

Large left-right deviation: loosen C, turn the locking ring, pay attention to the amplitude when turning, and use a little force (do not turn the motor part, that is, the position with SN code label).

向上调整：①松开B下面的螺丝，并上紧B螺丝

②松开A螺丝，并上紧A下面的螺丝

Upward adjustment:

① Loosen the screw under B and tighten the screw.

② Loosen the A screw and tighten the screw under A.

向下调整：①松开A下面的螺丝，并上紧A螺丝

②松开B螺丝，并上紧B下面的螺丝

Downward adjustment:

① Loosen the screw under A and tighten the A screw.

② Loosen the B screw and tighten the screw under B.

SUP20金属机型的调整方法

Adjustment method of SUP20 metal model