How to adjust the red light deflection: platform double swing head（本文适用以下枪头：SUP20SW150，SUP25A，SUP26A） (This article applies to the following gun heads: SUP20SW150, SUP25A, SUP26A). 1.只有红光可设置为其他形状的时候可通过下列方法调试，如果红光一只为点，请参照线变点处理方案，因为不摆动的时候也有可能会偏 2.如果从保护镜那边看到是一团光而非一条线，则考虑是否为反射镜断裂 3.请务必确认15V电源状态是正常 1. When only the red light can be set to other shapes, it can be debugged by the following methods. If only the red light is a point, please refer to the line change point treatment scheme, because it may be biased when it does not swing. 2. If you see a mass of light from the protective mirror instead of a line, consider whether the mirror is broken. 3. Please make sure that the state of 15V power supply is normal. 调整方案 1.软件设置（左右调整） 通过设置界面的激光中心偏移来微调，依次是{1.设置}-{2.更改对应的轴}。 这种方案可以进行左右的微调，如果使用这种方法依然无法调整，则使用机械调整 X- 光往← X+ 光往→ Y- 光往↓ Y+ 光往↑ Adjustment scheme 1. Software Settings (Left and Right Adjustment) Fine-tune the interface by setting the laser center offset, which is {1. Set }-{2. Change the corresponding axis} in turn. This scheme can be fine-tuned from left to right. If it still cannot be adjusted by this method, mechanical adjustment is used. X- Light direction ← X+Light direction → Y- Light direction ↓ Y+Light direction ↑
2.机械调整（上下左右调整） 在进行机械调整前，请务必把设置的各轴中心偏移设置为0 2. Mechanical adjustment (up, down, left and right adjustment) Before mechanical adjustment, be sure to set the set offset of each axis center to 0.
不同机型外观不一样，但是轴的位置相同，图片以SUP26A为例，打开盖板即可看到轴，稍微松开电机的禁锢螺丝，可以用手旋转（请勿大力旋转） X轴逆时针旋转 光往← X轴顺时针旋转 光往→ Y轴顺时针旋转 光往↓ Y轴逆时针旋转 光往↑ Different models have different appearances, but the position of the shaft is the same. Take SUP26A as an example. Open the cover to see the shaft. Loosen the screw of the motor slightly, and you can rotate it by hand (please do not rotate it vigorously). X axis rotates counterclockwise Light direction ← X axis rotates clockwise Light direction → Y axis rotates clockwise Light direction ↓ Y-axis counterclockwise rotation Light direction ↑ |
