送丝机软件说明：版本306（中英）

本文阐述版本号为306的软件说明，您可以通过设置页面查看系统版本后三位

This document describes the software version 306. You can view the last three digits of the system version on the Settings page

在此页面可以直接调整送丝速度，通过上下键调整

1.首页数值显示送丝速度，通过上下键来调整，使用时请保持运行状态

2.手动送丝：按住以后，送丝机开始送丝，手动送丝速度取决去后台设置

3.手动回抽：按住以后，送丝机开始回抽，手动回抽速度取决于后台设置

On this page, the wire feed speed can be adjusted directly by the up and down keys

1. The value on the home page shows the wire feed speed, which is adjusted by the up and down keys. Please keep the running state when using

2. Manual wire feeding: After holding down, the wire feeder starts to feed, and the manual wire feeding speed depends on the background setting

3. Manual pumping: After holding down, the wire feeder begins to pump back, and the manual pumping speed depends on the background setting

其他参数默认，一般只调整回抽长度和补丝长度

4.设置页面所有设置完成后都要点击一下保存

5.设置页面的送丝速度为默认送丝速度，即在此处更改后，开关机仍然保持不变

6.启动延迟：默认不设置

7;回抽长度和补丝长度：依照实际使用情况设置

当停止送丝后，系统会首先回抽一定的距离然后在送丝一定的距离，这个功能主要用于断丝

当出现每次焊接开始丝仍然在外面的情况，请设置回抽长度大于补丝长度即可

Other parameters default, generally adjust only the length of the draw back and the length of the wire

4. Click to save all Settings on the Settings page

5. Set the wire feed speed of the page as the default wire feed speed, that is, after changing here, the switch still remains unchanged

6. Startup delay: This parameter is not set by default

7. Drawing length and filling length: set according to the actual use

When the wire feed is stopped, the system will first pump back a certain distance and then a certain distance in the wire feed, this function is mainly used for breaking the wire

When the wire is still outside at the beginning of each welding, please set the withdrawal length to be greater than the length of the wire